Before Operating
√Know the machine. Learn its applications and limitations, as well as the specific potential hazards.
√Check for damage. If part of the machine is damaged, it should be carefully
inspected | to | ensure | that it can perform its | intended function correctly. If |
in doubt, | the | part | should be replaced. |
|
√ Be sure the switch is OFF before plugging in.
√ Before starting | machine check to ensure that all chuck keys, spanners and wrenches |
are removed from | the machine. |
√
√
Make sure guards are in place and working order.
Make sure tool has been cleaned and properly lubricated.
√ | Check for | damaged parts. Before | using any tool, any part that appears damaged should |
be | carefully | checked to determine | that it will operate properly and perform |
its intended | function. |
| |
√Check for alignment and binding of all moving parts, broken parts or mounting
fixtures and any other | condition that may | affect | proper operation. Any part |
that is damaged should | be properly repaired | or replaced | by a qualified technician. |
√Do not use the tool if any switch does not turn off and on properly.
Operation
√This drill press is designed for use with DRILL BITS and MORTISING ATTACHMENTS only. The use of other cutting tools or accessories could be hazardous.
√Always use clamps, or a drill vise bolted to the table, to hold the work. It should
never be | held | in | place | by | just your | hand. |
|
|
|
|
√ Never | force | the | tool | or | attachment | to do | the work | of a larger | industrial tool. | It |
is designed to do the job | better and | more | safely | at | the rate for which | it | ||||
was intended. |
|
|
|
|
|
|
|
|
| |
√
√
√
√
√
Always unplug the cord by the plug. Never yank the cord out of the wall.
Always turn off the machine before unplugging.
With normal use, the motor housing may get hot.
Make all adjustments to the machine with the power OFF.
Never stand on the machine. Serious injury could occur if the machine is tipped
over.
√Always use the correct drilling speeds for the drill size and the type of material being drilled
√
√
Never leave the drill unattended while it is running.
When turning off the machine, never leave unit it has come to a complete stop.
√Never hold material to be drilled with your bare hands. Damage to the machine may also occur if the flung material strikes the column.
#38144 | Page 5 |
