Hand Wheel Sewing Machine |
| Carriage Bolts (70j), |
(7b) | Belt (71j) | Flat Washer (69j), |
|
| Spring Washer (68j), |
|
| Nut (67j) |
Set Screws
(8b) (One on
each side of
the Pulley)
Main Shaft
(32b)
Slot in Tabletop for belt
Figure 7 Bobbin Winder Assembly
3.Slide the Sewing Machine Hand Wheel (7b) onto the Main Shaft (32b) of the Sewing Machine. Align one of the Set Screw holes (on the side of the Pulley) with the flat section of the Main Shaft.
Tighten the Set Screws (8b) enough to hold the Pulley in place, but not fully tightened.
Back of Sewing Machine
Slot with Pulley Belt
Carriage Bolts (70j)
flush with Tabletop
Back of Tabletop
Figure 8
4.Using a rubber mallet (sold separately) tap the three Carriage Bolts (70j) into the top of the Tabletop so that they are flush with the tabletop.
REV 04c; 07g, 10b
Figure 9
5.Mount the Motor to the underside of the tabletop using the Carriage Bolts (70j), Flat Washers (69j), Spring Washers (68j), and Nuts (67j). Finger tighten only.
Aligning the Pulleys
Belt (71j) | Motor |
| |
Set Screw (7j) |
|
Pulley (8j)
Figure 10
1.Place the Belt (71j) around the Sewing Machine Hand Wheel (7b), through the slot in the table top, and around the motor Pulley (8j). Make sure the motor pulley is in line with the Sewing Machine Hand Wheel. If you cannot get the Pulleys to line up by sliding them slightly in either direction, you may need to turn the Motor Pulley around. To do this, loosen the Set Screw (7j) on the motor Pulley, slide the Pulley off of the motor
SKU 3914 | For technical questions, please call | Page 9 |