Harbor Freight Tools 39213 installation instructions Center Panel

Note: Each Door is labeled indicating Right Door, Left Door, and Center Door.

6.Loosely set the Top Panel (#1) in place on top of the assembly you finished in steps one (1) through five (5) above. Make certain that the lip faces the front of the Hanging

Cabinet. Insert the Right Door (#11) into the holes in the Top and Bottom Panel. The Doors are attached with pins which set into holes; make certain to lay the Washer (hardware bag) over the pin prior to insertion. Insert the Center Door (#13) into the holes in the Top and Bottom Panel. Repeat for the Left Door (#15).

7.Once the Doors are in place, attach the Top Panel (#1) to the assembly by inserting two (2) Bolts (#6) down into the Right Side Panel (#7) and two Bolts (#6) down into the Left Side Panel (#16). Secure in place with Nuts (#5). Thread in remaining three (3) Bolts (#6) through the Top Panel (#1) and into Center Panel 1(#2) and Center Panel 2 (#3), and into center Back Panel (#8). Secure with Nuts (#5).

Large Nut

Washers

Screw

Key

Lever

Figure 3-Center Panel

Figure 4-Inserting Lock

8.Remove the large Nut off of the Lock (#14). Force the Lock (#14) into the hole in the Right Door (#11). Thread the large Nut back onto the Lock until it rests against the Door, securing the Lock (#14) in place-see Figure 4. Remove the washer and star- shaped lock washer from the Lock by loosening the screw on the end-see Figure 4. Slip on the locking lever so that when the key is turned the lever is horizontal, and then replace the washer and lock washer onto the Lock (#14)-see Figure 4 above. Repeat for the remaining two (2) Locks (#14).

Note: Each Lock (#14) comes with two (2) keys. Turning the key should move the lever to a horizontal position which will keep the Door from opening.

9.To hang the Cabinet, attach the two (2) Hangers (#4) to the right and left sides of the Back Panel (#8) with two (2) Bolts (#6). The Hangers (#4) should be attached to the Back Panel (#8) at different ends of the Cabinet so that when hung the weight is evenly distributed. Hang the Cabinet with the one (1) hole in each Hanger.

Warning: Make certain that the Bolt you use (not included) is sufficiently strong enough to hold the weight of the Hanging Cabinet and all contents of the cabinet. Make certain that the surface to which the Cabinet will be mounted will support the full weight of the Hanging Cabinet along with the weight of all tools and accessories which will be placed inside of the Cabinet.

REV 01i, 03j

SKU 39213 For technical questions, please call 1-800-444-3353. Page 4