Harbor Freight Tools 42528 manual Unpacking, Operation, Testing the Contact Safety Trip Mechanism

Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Unpacking

When unpacking, check to make sure the parts listed on page 9 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.

INCLUDED ACCESSORIES

3mm Hex Wrench	Tool Oil
4mm Hex Wrench	Assorted O-rings*

*NOTE: Although spare assorted O-rings are included,

these parts are for installation by a qualified technician only.

Operation

For best service, you should incorporate an oiler, regulator, and inline filter, as shown in the diagram below. Hoses, couplers, oilers, regulators, and filters are all available at Harbor Freight Tools.

Nailer

Note: To connect this tool, we recommend a quick coupler/adapter (not included). Coupler/ adapters are available at Harbor Freight Tools. For smoother operation, put 3-5 drops of pneumatic tool oil in the Air Plug (A-04) before each use.

Testing the Contact Safety Trip Mechanism

Warning: Even though the nailer should be empty during this procedure, ALWAYS point the nailer at a piece of scrap wood when testing.

1.Make sure the tool is disconnected from the power supply.

2.Completely empty the magazine of nails.

3.The Nailer should not fire if the nose is not depressed against the workpiece.

4.Check that the Trigger (A-26) and the Nose Piece (3-11) move freely, without sticking - see Figure 1, next page.

5.Connect the air supply to the tool at the Air Plug (A-04) set at the recommended 55-95 PSI, and not to go over the maximum 95 PSI.

SKU 42528 For technical questions, please call 1-800-444-3353. Page 5