To Use The Straight Guide:
1.The Straight Guide is used to make parallel cuts, or to make cuts on the edge of a work piece.
2.Assemble the Straight Guide (part #76) onto the Bar Holder Assembly (part #69), using the Wing Bolt (part #66). NOTE: Loosely hand tighten the Wing Bolt.
(Figure D)
3.Insert the two bars of the Bar Holder Assembly fully into the Base Plate, and securely tighten the two Wing Nuts (part #84). (Figure E)
4.Fine Adjust the desired distance from the Router Bit to the edge of the Straight Guide by turning the Feed Screw (part #70). When the desired distance is deter- mined, securely tighten the Wing Bolt (part #66) located on the Bar Holder Assembly (part #69).
5.Set the Base of the Router firmly against the surface of the workpiece, and align the Straight Guide with the edge of the workpiece. (Figure F)
76
69
66
Figure D
Figure F
Caution: Always make sure the workpiece is firmly clamped to the work surface before using the Plunge Router.
When using the Plunge Router, both hands should firmly grasp the Handles (#25 and #26) to insure complete control of the tool while it is being used.
|
|
|
| Figure E |
|
|
|
|
|
| |
|
|
|
|
|
|
SKU 43585 | For technical questions, please call | Page 7 | |||
