9.Stay alert. Watch what you are doing, use common sense. Do not operate any product when you are tired.

10.Check for damaged parts. Before using any product, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician.

11.Do not operate product if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the product.

Warning: The warnings, cautions, and instructions discussed in this instruc- tion manual cannot cover all possible conditions and situations that may oc- cur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Unpacking

When unpacking, check to make sure all parts shown on page 4 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.

Assembly Instructions

NOTE: All parts below refer to the parts listed on page 4 of this manual.

1.As shown in the diagram on page 5, position the U-Handle [1] inside the grooves of the Axle & Frame [4]. Attach the U-Handle to the Axle & Frame using two Bolts [10] on each side of the U-Handle. Add Washer (14) and secure the Bolts with Nuts [13] provided.

2.Position the Left Frame [7] inside the left groove of the Axle & Frame, opposite the end with the U-Handle attached. Secure the Left Frame using two Nuts and Bolts as shown in the diagram. Repeat for the Right Frame [8].

3.Attach the Bracket [9] to the Left and Right Frame pieces using the remaining Nuts and Bolts. Be sure that the folded edge of the Bracket points in toward the U-Handle.

4.To attach the Wheels [3], slide one of the Bushing [5] pieces over the Axle [11], followed by one of the Wheels. Secure the Wheel using a Washer [2] and Cotter Pin [6]. Repeat for the other Wheel.

5.Insert Caps [12] into the open ends of the tubing in the U-Handle, and the Left and Right Frame pieces.

SKU 44599

Page 3

REV 12/03

Page 3
Image 3
Harbor Freight Tools 44599 operating instructions Unpacking, Assembly Instructions