Miter Cuts
For Miter Cuts, you must use the Vise (#82). The Vise Stop has a
Fixed Splint (#100) for this purpose. Loosen the Vise Stop by slightly loosening each bolt and align the scale to your desired angle. Tighten the bolts. Carefully set the workpiece into the Vise (#82) without disturbing the setting.
Steel Cutting Capacities
Steel Pipe - 4” Dia. x 1/4” Wall Thickness Angle Iron - 4” x 4” x 1/2” Thickness Solid Steel -
Note: Use an aluminum oxide wheel for cutting ferrous material, i.e. angle iron, conduit pipe, etc. Use masonry wheels to cut masonry, stone, brick, aggregate, etc.
Maintenance
Warning! Remove the electrical plug from the outlet before maintaining the Saw.
1.Wearing gloves, carefully clean any excess metal filings that accumulate on the saw, vise assembly, or motor housing.
2.To keep looking like new, use an automotive wax to polish the metal
Base (#87).
3.Check blade for wear, replace at the first sign of any tears or cracks.
4.Periodically check power cord for wear or tears. If necessary, have a qualified technician replace it.
5.Never use chemicals or solvents to clean the Saw.
Lubrication
1.The motor bearings are permanently lubricated at the factory. Do not attempt to work on the motor; the tool should be serviced by a qualified technician.
2.Any mechanical part including a pivot or threaded rod may be lightly sprayed with a silicone or graphite lubricant, which will not hold or collect the metal filings left from a job.
3.Every 500 Hrs. replace the Carbon Brush (#67). Remove the
Brush Cap (#68) and take out the Carbon Brush (#67). Replace and tighten the Brush Cap (#68).
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 44829 | Page 5 | REV 04/02 |
