UNPACKING
When unpacking, check to make sure all parts shown on the Parts List (page 12) are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly Dia- gram on page 13 of this manual.
To Attach The Upper And Lower Tongs:
1.Caution: Prior to attaching the Upper and Lower Tongs (parts #46, #47), make sure the Spot Welder is disconnected from its electrical power source.
2.NOTE: Make sure the Upper and Lower Tongs (parts #46, #47) are clean and not cor- roded before installing. If necessary, clean the Tongs with steel wool.
3.To attach the Lower Tong (part #47) to the Spot Welder, loosen the four Cap Screws (part #3) located at the bottom/front of the tool. (See Figure A, and Assy. Diagram.)
4.Slide the Lower Tong (part #47) between the Tong Insulator (part #33) and Lower Tong Clamp (part #35), and position the Lower Tong so that the Tong Tip (part #48) faces up.
5.NOTE: Check to make sure the Lower Tong (part #47) will align with the Upper Tong (part #46) when fully assembled. (See Figure B, and Assy. Diagram.)
6.Retighten the four Cap Screws (part #3).
7.To attach the Upper Tong (part #46) to the Spot Welder, loosen the four Cap Screws (parts #3, #11) located at the top/front of the tool. (See Figure A, and Assy. Diagram.)
8.Slide the Upper Tong (part #46) between the Tong Top Holder (part #12) and Upper Tong Clamp (part #13), and position the Upper Tong so that the Tong Tip (part #48) faces down.
9.NOTE: Check to make sure the Upper Tong (part #46) will align with the Lower Tong (part #47) when fully assembled. (See Figure B, and Assy. Diagram.)
SKU 45689 | For technical questions, please call | Page 5 |
