WHEEL DRESSER HANDLE (5A) | WHEEL DRESSER HANDLE (5A) |
DIAMOND
WHEEL
ASSEMBLY
DRESSING
DIAMOND
GRINDING WHEEL (21A)
FIGURE B
3.Lower the Wheel Dresser Handle (5A) so that the Diamond Wheel Assembly is facing the flat side of the Grinding Wheel (21A). (See Figure B, and Assy. Dia- gram A.)
4.Adjust the Diamond Wheel Assembly inward until the Dressing Diamond (in- cluded as an accessory) contacts the Grinding Wheel (21A). (See Figure B, and
Assy. Diagram A.)
5.Turn the Power Switch (1F) to its “ON” position. As the Grinding Wheel (21A) spins, move the Wheel Dresser Handle (5A) to the right and left while, at the same time, slowly adjusting the Diamond Wheel Assembly inward no more than 0.0078” (0.2mm). (See Figures A, B, and Assy. Diagrams A, and F.)
6.Continue the dressing process in Step #5 above until the flat side of the Grinding
Wheel (21A) is completely smooth and its edge is sharp. (See Figure B.)
7.Turn the Power Switch (1F) to its “OFF” position, and wait until the Grinding Wheel (21A) has completely stopped spinning. Then, adjust the Diamond Wheel Assembly outward, away from the flat side of the Grinding Wheel, and raise the Wheel Dresser Handle (5A) to its original position. (See Figures A, B, and
Assy. Diagrams A, and F.)
SKU 45707 | For technical questions, please call | Page |
