Installation
1.Place the Saw on the solid workbench capable of supporting the weight of the Miter Saw and all work pieces. (Do not carry the unit by the Handle or misalignment of the components may occur.)
2.Using a pencil, mark through the saw Base (118) holes onto the workbench.
3.Drill four 3/8 inch holes into the workbench for the mounting hardware.
4.Secure the unit to the workbench using bolts, nuts, lock washers (not supplied).
5.Insert the Bracket (121) into the holes on either side of the Saw.
6.Insert the material Clamp (123) into either side of the Base.
7.Check and tighten all bolts and adjustment screws.
8.Insert the Dust Collection Bag.
Operation
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known [to the State of California] to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•Lead from
•Crystalline silica from bricks and cement or other masonry products
•Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California Health & Safety Code 25249.5, et seq. )
Caution:
The wood to be cut needs to be positioned under the center of the saw blade. If you are cutting a small workpiece, use a spacer block to move the wood to be cut so that you are cutting lined up with the center of the blade.
SKU 45885 | Page 5 |
45885.p65 | 5 | 10/15/03, 10:41 AM |
