Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Operation Instructions
Blade Alignment
•The Clipper comes oiled and aligned from the factory. Blades must be realigned after they have been removed for cleaning or replacement.
1.To realign blades, match the upper and lower blades teeth up, point for point. The end of the top blade teeth should be approximately 1.2mm (just under 1/16”) back from the bottom blade.
2.If blade alignment is incorrect: add a few drops of oil to the blades, turn the Clipper on for a few moments, then turn off and unplug. Loosen screws slightly and readjust. Tighten screws after blade is aligned.
•Blades should be oiled every few haircuts to maintain the Clipper in peak condition.
•Do not use hair oil, grease, or any solvent on the Clipper. The solvent will evaporate and leave a residue that can slow down the blade’s motion.
Power Screw
•The power screw, located on the side of the Clipper, allows the power level of the Clipper to be adjusted. The power screw has been
1.To adjust, use a screwdriver to turn the power screw clockwise until the arm strikes the coil. When the arm touches the coil it will begin to make noise.
2.Slowly turn power screw counterclockwise until the noise stops. This is the maximum power setting.
Note: DO NOT remove power screw.
Blade Lever
•The Blade lever allows the operator to change the closeness setting of the cut without an additional attachment comb.
•At the top position, the blades will give the closest cut and leave the hair the shortest. Pushing the lever downward increases the cutting length.
•If hair jams the blades, switch the Blade Lever up and down rapidly to clear the blades.
SKU 47082 For technical questions, please call | Page 4 |
