Operation Instructions
NOTICE: To prevent blowing a fusible link on the receptacle, only use with 12V accessory power outlet.
1.Place the Power Switch (11) and the LED Switch (16) in their O (off) positions. Plug into a 15A rated 12V accessory power outlet ONLY.
Note: This heater can burn out lighter sockets.
2.Mount on dashboard, or hold over windshield for spot defrosting. Use for up to 20 minutes, and then shut off for at least 5 minutes.
3.The Heater can be removed from the Mounting Base (6). By holding the Handle (4/5) the Heater can be moved around as needed.
4.The LED Switch (16) turns the lights on/off.
5.To select either the fan only or the heater and fan, press the Power Switch (11) to the setting as marked. Toggle the Power Switch to the center position to turn off these functions.
WARNING! Do not operate longer than 20 minutes at one time, allow heater to cool completely after use.
6.Unplug the Heater before leaving the vehicle.
If heater suddenly stops operating:
WARNING! TO PREVENT FIRE: Replace fuse only with fuse of same type and rating.
1.Pull the Fuse (12) out of the Fuse Holder (18).
If the wire inside the Fuse is broken the Fuse needs to be replaced, otherwise insert the Fuse back into the Holder and proceed to the next step.
2.If the heater’s Fuse was not blown, connect another 12VDC device to the 12V accessory outlet to check it.
a.If the receptacle works, have the heater serviced by a qualified technician.
b.If the receptacle does not work,
DO NOT USE THIS HEATER WITH THAT RECEPTACLE.
That receptacle is evidently not rated to 15A, as this Heater requires.
Note: Check vehicle’s service manual for instructions on repairing the receptacle. Likely failure points are the fusible link on the receptacle itself or the vehicle’s fuse.
Item 60525 | For technical questions, please call | Page 5 |
