Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Installing the Fence and Stop
Block
1.Set the Fence (76) down onto the Block (89) by setting the locating pin at the bottom of the Fence into the key hole slot on top of the Stand (75).
2.At the same time, set the
3.Use a
4.Slide Fence slightly to the side so it fits snug into place.
5.Secure with Hex Nut. Do not over- tighten.
6.Turn Screw on bottom of Fence clockwise to further secure.
Figure 1
Stop
Block (25)
7.Set the Stop Block (25) against the
Fence by rotating it until it’s flat edge points toward the Fence and it sits firmly up against Fence. Make cer- tain not to use excessive force to rotate the Stop Block. It should easily
move into place against the Fence. See Figure 1.
8.Stop Block must always snap back in place and close instantly. Do not use Jointer Planer if Stop Block does not adequately snap into place.
9.Loosen the tension on the Stop Block if Jointer Planer will not be used for a significant time period. Please note: Fence must be removed.
Installing Dust Collection Bag
Figure 2
1.Slide Dust Collection Collar (106) over Dust Collection Bag (107).
2.Slide Dust Collection Bag (107) with Dust Collection Collar onto Port.
3.Tighten Dust Collection Collar (106) in place by turning Handle and then clamping Handle down once reason- ably tight. Do not overtighten. See Figure 2, previous page.
Fence Adjustment
Turn the Switch (2) to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjust- ments to the tool.
SKU 65673 | For technical questions, please call | Page 9 |
