Page 2SKU 9766-67 For technical questions, please call 1-800-444-3353.
assembLY instructions
read the entire important
saFetY inFormation
section at the beginning of
this document including all
text under subheadings
therein before set up or use of
this product.

installation

The planned mounting area must 1.
provide a ush t to the bottom of the
Lights (1).
Remove the lens from each Light and 2.
use the base of the Light as a template
to mark mounting holes.
Ensure that the installation area has no 3.
hidden electrical or stereo lines before
drilling.
Drill the holes, then secure each of 4.
the Lights with two Long Screws (2).
Replace the lens.
See Wiring Diagram, page 4.5.
Connect the wire of each of the Lights 6.
to the Lead Wire (8) using a Wire
Splice (4). Insert the two wires into the
holes of the Splice and use pliers (not
included) to push down the metal tab.
Close the cap to secure.
holes for
wires
metal tab
cap
Wire splice (4)
7. If the Lights are intended to be used
along with the vehicle’s main lights,
connect the lead wire to the headlight
switch positive terminal.
If the Lights are to work independently 8.
of the vehicle’s lights, mount the Switch
at a convenient location with the two
Short Screws (3).
Connect the Lead Wire to the middle 9.
terminal of the Switch (7).
Connect the Fuse Holder (5) to the top 10.
terminal and connect to a 12V power
supply.
Connect the Ground Wire (6) to the 11.
bottom terminal of the Switch and the
other end to ground.
This product is intended only to be 12.
mounted on the top of a vehicle’s cab.
Installation of these products must 13.
comply with DOT regulations and all
applicable State and local laws.
pLease read the FoLLoWing careFuLLY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND
ASSEMBLy DIAGRAM IN THIS DOCUMENT AS
A REFERENCE TOOL ONLy. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES
ANy REPRESENTATION OR WARRANTy
OF ANy KIND TO THE BUyER THAT HE OR
SHE IS qUALIFIED TO MAKE ANy REPAIRS
TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIFIED TO REPLACE ANy PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR ExPRESSLy
STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN
By CERTIFIED AND LICENSED TECHNICIANS,
AND NOT By THE BUyER. THE BUyER
ASSUMES ALL RISK AND LIABILITy ARISING
OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.