2.WARNING! Hold the Nailer pointed away from you and any other people or fragile objects. HOLD THE PUSHER BACK DURING THIS OPERATION AND BE CAREFUL NOT TO BUMP THE LATCH.
3.Press down on the two Guide Drive Latches (59) at the top of the Magazine.
4.Carefully lift the Cover Plate (58) off the Drive Guide (54) and use pliers to remove any stuck fasteners from the jammed Nailer.
5.Inspect the Driver Guide for any bends or breakage. If it is damaged, do not use the Nailer until it is repaired by a qualified technician.
6.Lightly oil the Driver Guide and replace the Cover Plate. Release the Drive Guide Latches, locking the Cover Plate in place.
7.Reload the Nailer.
8.Reconnect the Nailer to the air hose.
9.Press the Safety against an appropriate piece of scrap wood and test fire the
Nailer several times, checking for proper operation.
10.Disconnect the Nailer, remove the fasteners, and store the Nailer in a location out of children’s reach
11.If a fastener is jammed in the Magazine, pull the Pusher back until it locks into place at the back of the Magazine.
12.Use a screwdriver to release the jammed fastener by probing the openings in the Magazine.
13.Pull out the jammed fastener and the remainder of the fastener strip that is still in the magazine. Dispose of the remaining fastener strip; it may be bent or damaged in some other way.
14.Once the jam is cleared, insert new fasteners into the Magazine. NOTE: Make sure the fasteners are loaded with the pointed ends facing downward.
15.Hold the Pusher in place while pressing the Latch, unlocking the Pusher. WARNING! The Pusher is
16.If you are unable to clear the fastener jam using the method prescribed above, the tool should be taken to a qualified service technician for proper servicing.
Page 14 | For technical questions, please call | SKU 68023 |
