Harbor Freight Tools 69342 owner manual Cleaning, Maintenance, and Lubrication, Troubleshooting

y fet Sa

Maintenance and Servicing

Procedures not specifically explained in this manual must be performed only by a qualified technician.

To prevent serious injury from accidental operation:

Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

To prevent serious injury from tool failure:

Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.

Cleaning, Maintenance, and Lubrication

Setup

1.BEFORE EACH USE, inspect the general condition of the tool. Check for:

•loose hardware,

•cracked or broken parts,

•damaged electrical wiring, and

•any other condition that may affect its safe operation.

2.After Use, wipe external surfaces of the tool with clean cloth.

3.WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.

no rati Ope

ec

Troubleshooting

Problem		Possible Causes		Likely Solutions
Heat Gun will	1. Cord not connected.		1.	Check that cord is plugged in.
not turn on.	2.	No power at outlet.	2.	Check power at outlet. If outlet is unpowered,
				turn off tool and check circuit breaker. If breaker
				is tripped, make sure circuit is right capacity
				for tool and circuit has no other loads.
	3.	Power Switch set at “0”.	3.	Turn Power Switch to “I” or “II”.
	4.	Internal damage or wear.	4.	Have technician service tool.
		(Switch, for example.)
Unsatisfactory	1.	Inappropriate heat for task.	1.	Adjust heat setting or distance to
results.				workpiece to compensate.

Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.

Maintenan

Page 10 For technical questions, please call 1-800-444-3353. Item 69342