OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on page 14.
1.
WARNING! Remove the Battery (4) from the tool and set the Rotation Button (33) to its center, locked position before making any adjustments, changing accessories, or storing the tool.
CHUCK SLEEVE
CHUCK (12) 
TORQUE
SETTING
RING (8)
TORQUE
INDICATOR
ARROW
ROTATION
BUTTON (33)
TRIGGER
(3)
BATTERY PACK (4) 
FIGURE E
2.To install a drill/screwdriver bit, hold the Chuck Sleeve firmly in place and turn the Chuck (12) counterclockwise. Insert the shank of the bit all the way into the Chuck (12). While holding the Chuck Sleeve in place, turn the Chuck clockwise to lock the bit in place. The Chuck (12) accepts up to 3/8” diameter bits. Insert the appropriate bit for your application and tighten the Chuck (12) firmly. (See Figure E, above.)
3.Secure the workpiece in place, using a vise or clamps (not included).
4.The Torque Setting Ring (8) allows you to select 16 different driving torque settings, depending on the job required.
Torque Settings
The different numbers on the Ring are an indication of how much torque the screwdriver will apply to the bit before the clutch slips, allowing the bit to stop and helping to prevent damage to the screw, bit, or workpiece. The higher the number, the more torque is applied before the clutch slips. Unless you are drilling, always start with a lower number to help prevent damage. This drill also has torque settings between the numbers to allow a greater range of control.
SKU 90120 | For technical questions, please call | PAGE 11 |
