Harbor Freight Tools 90385 operating instructions Specific Safety Rules for this Product

SPECIFIC SAFETY RULES FOR THIS PRODUCT

1.Maintain labels and nameplates on the Air Compressor. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement.

2.Maintain a safe working environment. Keep the work area well lit. Make sure there is adequate surrounding workspace. Always keep the work area free of obstructions, grease, oil, trash, and other debris. Do not use a power tool in areas near flammable chemicals, dusts, and vapors. Do not use this product in a damp or wet location.

3.Avoid unintentional starting. Make sure you are prepared to begin work before turning on the Air Compressor.

4.Do not force the Air Compressor. This tool will do the work better and safer at the pressure and capacity for which it was designed.

5.Always unplug the Air Compressor from its electrical outlet before performing and inspection, maintenance, or cleaning procedures.

6. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement or other masonry products, arsenic and chromium from chemically treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California Health & Safety Code § 25249.5, et seq.)

7. WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.

8.Never leave the air compressor unattended while running. Turn power off if you have to leave the mixer.

9.Before each use, check all nuts, bolts, and screws for tightness. Vibration may cause these to loosen.

10.Always connect the Line Cord to a Ground Fault Circuit Interrupter (GFCI) protected electrical outlet. Always use a 115V electrical source (+/- 10% maximum variation).

11.Drain compressor every day. Do not allow moisture to build up inside the compressor. Do not allow compressor to sit pressurized for longer than one hour.

12.Make sure all equipment is rated to the appropriate capacity. Adjust the output air pressure to the tool’s operating capacity.

13.Avoid body injury. Never direct the air outlet at persons or animals.

REV 11/04

SKU 90385 For technical questions, please call 1-800-444-3353. Page 5