Maintenance
1.Before the first use, and once a month following, put a few drops of oil on the Shaft Sleeve (14) bearings.
2.Check the Belt (37) tension. It must be kept as loose as possible without allowing it to slip on the Driving Pulley (35). Check periodically.
To Adjust Belt (37) Tension:
a.Unplug the Power Cord (15) from its outlet.
b.Remove the four Bolts (1) holding the Top Cover (2) on.
c.Remove the Top Cover (2), Middle Plate (5), and Pads (3, 7), they should come off as one assembly, and set them aside.
d.Loosen all four Round Cap Nuts (21) slightly, enough to allow them to move back and forth.
e.Slide the Motor (17) away from the Power Switch (13) to increase tension, or towards the Power Switch (13) to reduce tension or even remove the Belt (37).
f.Inspect the Belt (37) for cracks, tears, or other damage. Replacement Belts (37) are sold under Sku 93835.
g.Reinstall the Middle Plate (5) and Top Cover (2) using the four Bolts (1).
3.Make sure the exterior of the Rubber Barrel (22) is clean so that it doesn’t slip on the rollers. Wipe it with a soapy cloth, then wipe it clean with a damp cloth, and dry thoroughly. Do not use liquid cleaners or solvents.
REV 01/06
SKU 90979 | For technical questions, please call | Page 8 |
