2.Slide the Handle (1) down into the Body
Figure 2
Middle |
|
|
| Handle (1) | ||
|
|
| ||||
|
| Body (4) | ||||
Tray (11) |
|
|
|
| ||
|
|
| ||||
Wheel (7)
Sleeve (5) | Axle (6) |
|
Figure 3
Stretcher (15)
Pins
Install Locking Washers (10)
Nut (9)
Lower Tray (12)
3.Slide the Axle (6) through each of the eyelets located at each side on the bottom of the Body (4). Slide one Sleeve (5) onto each end of the Axle
4.Slide Wheel (7) over the Sleeve (5). Place Washer (8) on end of Axle (6) and thread on Nut (9) to secure Wheel (7) in
5.Set the Stretcher (15) over the pins located on the sides of the Body (4) near its
6.Snap the Middle Tray (11) into place at the top of the Body (4) as shown in Figure 2.
7.The Lower Tray (12) is to be installed at the bottom of the Body with part of it resting on the Platform
8.The Garden Cart can now be used to carry and tranport garden tools. Roll the Garden Cart to the desired location. Locate a solid, firm and level location that is capable of supporting the Garden Cart and it’s load. Fold out the Platform (13) so that the Platform (13) rests on the ground. Make certain that the Platform snaps into place and is secured by the Quick Lock/Unlock Mechanism
9.The Garden Cart can hold a plastic bag (not included) for collection of trash and debris. Pull down on the Stretcher (15) until it is fully extended. Set a plastic Bag so that it rests over the Stretcher (15), and roll and tuck the inside of the plastic bag (not included) into the slots on the Body
Lock/
Unlock Mechanism (14)
Platform (13)
Figure 4
Stretcher (15)
Figure 5
Bag not included
SKU 91121 | Page 4 |
