Unpacking
When unpacking, check to make sure the following parts are included that are listed on Page 4. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Assembly and Usage Instructions
The Gravity Spray Gun Holder holds most cup style GRAVITY FEED spray guns.
1.At one end of the Steel Rod (4), attach Ring Holder (3) using a Washer (2) on each side of the Ring Holder and Tighten with Nut (1). This Ring Holder is used to hold a strainer (not included) as an aid when filling the spray gun cup with paint.
2.Attach the other end of the Steel Rod (4) through the Holding Bracket (6) using Washers (2) and Nuts (1). Attach Base (7) to the Holding Bracket (6) using Bolts (5), Washers (2), and Nuts (1). See Figures 1 and 2.
3.Your spray gun will rest on the Holding Bracket (6) as needed. Be careful not to tip or bump the holder as it may fall.
IMPORTANT:
Refer to the manual of the paint spray gun and paint you will use
for necessary warnings and instructions before use.
Ring Holder (3)
Steel Rod (4)
Holding 
Bracket (6)
Holding
Bracket (6)
Base (7)
Washer (2)
Bolt (5)
. | Figures 1 Maintenance | Figures 2 |
|
1.Keep indoors to avoid rust.
2.Wipe surfaces with a damp cloth or paint thinner, depending on what type paint was used. Rinse off and dry thoroughly. Use Caution: Paint thinner is flammable and must be disposed of and stored properly.
SKU 91603 | For technical questions, please call | Page 3 |
