Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Assembly and Operation
Your Two Burner Propane Stove will require some simple assembly as described in the following steps. To assist you with assembly and operation please refer to the Operational Figures as well as the Assembly Diagram and Parts List located on the last pages of this manual.
1.Pull the Latches (6) up from the top and around to the bottom of the
2.Make certain that the stove is on a flat, level surface capable of supporting the weight of the Stove and the items to be heated. Raise the Cover (1), then raise the Side Shields (2) on both sides of the Stove. Insert the tabs on the Cover (1) through the hole in the side of the Side Shields (2). Raise each Side Shield (2) completely into place so that the tab locks into place at the end of the groove.
Figure 1
Burner and Fuel
Jet Assembly (7)
Side Shield (2)
Latch (6)
Burner Control Knob (8)
Tube and Valve Adapter (4)
Figure 2
Attach to propane canister (not included)
Thread onto
StoveTube and Valve
Adapter (4)
3.Thread the Tube and Valve Adapter Assembly (4) onto the
4.Make certain that both the Burner Control Knobs (8) are in the OFF position before attaching the propane canister (not included).
5.Attach the other end of the Tube and Valve Adapter (4) to the propane canister (not
included). | For technical questions, please call |
|
SKU 91614 | Page 4 |
