OPERATING INSTRUCTIONS
1.Place the Fireplace Heater in the desired location for operation.
This place must be away from curtains and any other flammable material. If an extension cord is used, it must be of the appropriate size (See page 6.). The electrical outlet must be at least a 15 amp circuit.
2.Press the Fan Switch up to turn it on. (See Figure C below.)
3.Press the 750W Switch to enable medium heat. Press the second 750W Switch to enable maximum heat.
4.Adjust the Temperature Thermostat Knob to the desired temperature (clockwise is maximum).
When the unit reaches the desired temperature, the unit automatically shuts off. When the room temperature cools down, the unit will automatically turn on.
Note: The Remote Control can be used to turn the unit on and off, and to adjust the temperature.
5.Press the Fire Switch to turn on the fire lights inside the imitation logs. Turn the Brightness Knob to the desired light level (clockwise is maximum).
6.When finished using the Fireplace Heater, press all switches down to the off position, and unplug the line cord from the electrical outlet.
Figure C Control Panel
Temperature Thermostat Knob | Brightness Knob |
Fan | 750W | 750W | Fire Lights |
INSPECTION, MAINTENANCE AND CLEANING
WARNING! Make sure that all Switches of the Fireplace Heater are in the “OFF” position and that the unit is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
1.Before each use, inspect the general condition of the Fireplace Heater. Check for
SKU 91797 | For technical questions, please call | Page 7 |
