9.Wear gloves and avoid sharp edges when assembling.
10.Make certain that the Greenhouse is placed on a falt, level, solid surface capable of supporting the Greenhouse.
11.Because of aluminum dust, be certain to wash your hands after handling the Greenhouse.
12.Never allow children to play with this product. Caution: Small parts can be easily swallowed by small children.
WARNING: This product contains or, when used, produces a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
(California Health & Safety Code 25249.5, et seq.)
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your Miniature Greenhouse, check to make sure the following parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
Assembly/ Operation
Your Miniature Greenhouse will require complete assembly prior to use. It is important that you read the entire manual to become familiar with the product BEFORE you assemble and use the Greenhouse. Before assembling and operating the Greenhouse be sure that you have all parts described in the Parts List and Assembly Diagram located on the last pages of this manual.
Note that throughout the assembly process all parts of the Greenhouse frame will be attached using the Bolts and Nuts (11) provided. Parts have been labeled with the appropriate part number to help with assembly. Refer to the assembly diagrams and figures for all steps. Do not install Windows until specified in the assembly directions.
1.Attach Back (1) to both Sides (2). Make certain that all sides are square and that edges overlap appropriately. Insert Bolts (11) through each hole in the corner and thread on Nuts
Figure 1-Attaching 1 to 2
| Bolts and Nuts (11) |
|
SKU 92050 | For technical questions please call | Page 3 |
