5.Depress the “SET” button on the Charger (17). The Green Light will automati- cally go out, and the Red Light will turn on indicating the Charger has switched to the charge mode. (See Figure A.)
6.In approximately 1 hour, when the Battery Pack (3) is fully charged, the Red Light will automatically go out, and the Green Light will turn on. Remove the Battery Pack from the Charger, and disconnect the Charger from its electrical outlet.
(See Figure A.)
7.NOTE: The temperature of the Battery Pack (3) may increase during use and shortly after use. The Battery Pack may not accept a full charge if it is charged immediately after use. Allow the Battery Pack to cool to room temperature before charging for best results. (See Figure A.)
CHARGER
(17)
(TOP VIEW)
BATTERY PACK
(3)
|
|
| CHARGER |
|
|
|
|
| |||
| (17) |
|
| ||
RED LIGHT |
|
| “SET” BUTTON |
|
|
|
|
|
| ||
| GREEN LIGHT |
|
| ||
(CHARGE MODE) |
|
| FIGURE A | ||
| |||||
|
|
| |||
TO INSTALL A GREASE CARTRIDGE
1.Pull back on the Follower Handle (19) until the Follower Rod (22) is fully ex- tended. Then, turn the Follower Handle and latch the Follower Rod into the slot on the end cap of the Grease Tube (2). (See Figure B, next page.)
2.Unscrew and remove the Grease Tube (2) from the Pump Housing (6).
(See Figure B.)
3.Remove the plastic cap from a grease cartridge (not included), and insert the cartridge into the Grease Tube (2). (See Figure B.)
SKU 92196 | For technical questions, please call | PAGE 7 |
