Maintenance
1.Make sure your Impact Wrench is disconnected from the air hose before attempting any maintenance.
2.Wipe the Impact Wrench down with a lint free cloth after each use.
3.Make sure the Anvil (31) is clear of dirt or debris. If possible, spray it with compressed air before each use.
4.Annually, or more often if used on a daily basis, use a grease gun (not included), to inject grease into the Grease Fitting (7). See FIGURE 3.
5.If you do not use an inline oiler/filter system, lubricate the tool daily by holding it so that the Inlet (6) is facing up. Squeeze the Trigger (14), and place one or two drops of oil into the Inlet (6). Squeezing the Trigger (14) allows the oil to circulate in the motor.
FIGURE 1
Regulator
Knob (12)
Inlet (6)
Trigger (14) | Anvil (31) |
FIGURE 2
FIGURE 3
Grease
Fitting
(7)
Turn the Regulator Knob (12) to change the amount of power that the tool puts out.
Forward | Reverse |
SKU 92453 | For technical questions, please call | Page 6 |
