SKU 92464 Page 5
For technical questions, please call 1-800-444-3353.
Connection
For the power inverter to work properly, your power source must provide 12 volts
DC, and the power source must provide enough current (i.e., 46 amps to operate
the load of 560 Watts or under).
Caution: This inverter must only be connected to batteries with a nominal
output voltage of 12 volts. Lower voltage will not operate the inverter properly,
and more voltage could damage the inverter or the device being powered. If
more than one 12 volt battery is to be used, the batteries must be connected
in a parallel circuit; batteries connected in a series circuit will produce too
much voltage.
1. Place the Power Inverter on a flat surface. Make sure it has adequate ventilation
and is not in direct sunlight. Fasten the inverter securely to the surface, using
screws or some other means. If holes are to be drilled, follow safe, proper
installation techniques.
2. Connect the Battery Cable (not included; #2 AWG or larger cables recommended)
lugs to the (Positive) red and (Negative) black terminals on the back of the
Inverter, see BACK above. Connect the Ground Cable (not included; #4 AWG
or larger cable recommended) lug to the Ground terminal, see BACK above.
Securely tighten.
3. The Power Inverter can be used either while the engine is running or off.
Connect the Battery Cables (not included) to the Negative (black) and Positive
(red) terminals of the battery.
4. Connect the Ground Cable to the appropriate location below:
a. If this unit is mounted within a vehicle with a grounded metal chassis,
attach the Ground Cable to a nearby location on the chassis.
b. If this unit is mounted in a boat or vehicle with an ungrounded chassis,
attach the Ground Cable to the vehicle’s grounding system.
c. ONLY if this unit is being used outside a vehicle,
attach the Ground Cable to the Negative Terminal of the Inverter.

BACK

NegativeGround Positive WARNING!
Risk of Fire!
The positive battery
terminal connection
must be the LAST
connection and must
be done with the in-
verter’s switch off.
REV 06/06