Harbor Freight Tools 92928 manual Insert the Nylon Base 5 onto each vertical leg

2.Connect 3-way and 4-way Tube Fittings (2 and 3) as shown below. At each junction, there is a hole through the side of the Fitting that lines up with the hole in the side of the Tube. Line up these holes on the inside of the structure and insert Self-tapping Screws (8), but tighten them only slightly at this time.

3.Drape Tarp (7) over assembled frame and secure the corners (first) onto the frame using the Ball Tie Downs (4) as shown in 4A, B, and C, below.

4.Once the corners are fastened, place the Ball Tie Downs through the balance of the metal eyelets as shown in the previous illustration, 4D.

5.Lift one side of the roof and slide in four Steel Tubes (1). Line up the holes in the Tubes with the holes in the Fittings and insert Self-tapping Screws (8), but tighten them only slightly at this time.When

complete, do the same to the other side. See illustration to the right.

6.Insert the Nylon Base (5) onto each vertical leg.

7.Secure each Nylon Base to the ground

	Nylon Base (5) fits here.
		REV 09e
SKU 92928	For technical questions, please call 1-800-444-3353.	Page 4