11.Do not allow children to play with, stand upon or climb on the Walker.
12.Always check hardware and assembled parts after assembling. All connections should be tight and hardware tightened.
SPECIAL WARNINGS FOR THIS PRODUCT
1.Before use, make certain your Walker is fully opened, the seat is down completely, and the folding bar beneath the seat is in the locked position.
2.Check that both handles are at equal heights. If one is lower than the other, adjust accordingly. Apply gentle pressure to the Handles to test the stability of the Walker before use.
3.Test brakes thoroughly before use. The brake bar on the wheels will prevent the wheels from rolling when the brake is set in the locked position. If the wheels turn while the brakes are locked, have the brakes adjusted by an authorized technician. Under no circumstances should you use this product if the brakes do not lock properly.
4.Always put brakes in the locked position before sitting on the seat. Do not sit on the seat unless you are on even, level ground.
5.Check tires periodically and replace when worn.
6.This product is not a cart or a wheel chair. Do not use it to push or carry people or objects (except for objects in the basket). Do not load more than 25 Lbs. in the basket.
7.Do not exceed the maximum load capacity of 250 Lbs.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your Walker, check to make sure that all of the parts listed on page 5 are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
Assembly
Your Walker will require minor assembly before use. It is important that you read the entire manual to become familiar with the product BEFORE you use the Walker. Before using the Walker, check to make sure that the product is intact, undamaged and working properly.
Handles
If not already in place, set one Collar (21) securely onto each side of the Front Frame (20). Insert the Handle (10) down into the Front Frame (20). Loosen the Knob (22) and insert the Handle (10) down through the Collar (21) on each side of the Handle
Attaching the Back rest Bar (6)
1.Insert both ends of the Backrest Bar (6) with Foam Tubing (7) down into the fitting located at the front of the Front Frame
Bar (6) down into the fitting. Release the |
| |
SKU 92987 | For technical questions please call | Page 3 |
