Harbor Freight Tools 93359 operating instructions Extension Cords

EXTENSION CORDS

1.Grounded tools require a three wire extension cord. Double Insulated tools can use either a two or three wire extension cord.

2.As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage. (See Figure C, below.)

3.The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord. (See Figure C.)

4.When using more than one extension cord to make up the total length, makesure each cord contains at least the minimum wire size required. (See Figure C.)

5.If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Figure C.)

6.If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.

7.Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it.

8.Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.

Figure C.

Recommended Minimum Wire Gauge for 120 Volt Extension Cords*

Nameplate
Amperes (At			Extension Cord Length
Full Load)
		25 Feet	50 Feet	75 Feet	100 Feet	150 Feet
0 - 2.0		18	18	18	18	16
2.1	- 3.4	18	18	18	16	14
3.5	- 5.0	18	18	16	14	12
6.1	- 7.0	18	16	14	12	12
7.1 - 12.0		16	14	12	10	X
12.1	- 16.0	14	12	10	X	X
16.1	- 20.0	12	10	X	X	X

SYMBOLOGY

	Double Insulated
	Canadian Standards Association
	Underwriters Laboratories, Inc.
V ~	Volts Alternating Current
A	Amperes
no load xxxx per min.	No Load Revolutions per Minute

SKU 93359 For technical questions, please call 1-800-444-3353 Page 6