9’ UMBRELLA
w/Aluminum Pole
93660
Materials:
100% polyester, antique beige colored fabric. UV treated, mil- dew resistant with eight ribs, 9 ft. long, and an aluminum pole with a tilt mechanism that will angle at a 45 degree angle, left or right.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
Copyright © 2005 by Harbor Freight Tools ®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
UNPACKING
When unpacking, check to make sure all parts shown on the back of this instruction sheet are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the front of this sheet as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: All parts below refer to the parts listed on the reverse side of this instruction sheet.
1. Caution: DO NOT attempt to use this Umbrella in moderate or high wind conditions. Doing so may cause personal injury and/or damage to the Umbrella and personal property. Be careful not to pinch fingers when opening and closing the Umbrella.
2. To assemble, insert Lower Pole (8) with its threaded end upward, securely into a heavy duty umbrella stand.
NOTE: This Umbrella is intended for use only with a heavy duty umbrella stand which is not provided with this product. Adjustable, heavy duty umbrella stands are sold separately by special order from Harbor Freight Tools (SKU 94041).
3. Screw the Connector/Crank (7) onto the threaded end of the Lower Pole.
4. Screw the Upper Pole (6), with its
5. Hand crank the Connector/Crank clockwise in order to raise the Hub/Runner (5) above the
6. If you wish to tilt the upper part of the umbrella for shade, press the “push button”. It will tilt to a 45 degree angle. To straighten up, reverse the tilt until the tilt mechanism “clicks” into place for safety. Note: When tilting, opening, or closing the umbrella, watch your head for injuries. See Figure 1.
7. When finished using the Umbrella, crank the Connector/Crank counterclockwise until the upper umbrella assembly is completely closed.
Figure 1
CLEANING AND MAINTENANCE
1. To clean, fully open the Umbrella. Wipe with a clean, damp cloth, using a mild soap with water if necessary.
2. Periodically, lightly lubricate all moving parts.
SEE REVERSE SIDE OF THIS INSTRUCTION SHEET FOR PRODUCT WARNINGS, PRECAUTIONS, PARTS LIST, AND ASSEMBLY DIAGRAM.
