Harbor Freight Tools 93884 Changing or Installing Batteries, General Maintenance

Maintenance

Changing or Installing Batteries

1.To change the “AAA” batteries that power the Laser, remove the End Cap (14) and set it aside. See FIGURE 2, below.

2.Remove the old batteries and replace them with two fresh batteries. Make sure that you match up the positive (+) and negative (-) ends to the diagram on the side of the level. See FIGURE 2, below. Replace the End Cap (14).

FIGURE 2

Battery Polarity

Direction

End Cap (14)

3.To change the 9 Volt battery that powers the LCD (3), remove the Battery Cover (16) by first removing the Screw (15).

4.Install a fresh battery making sure you match up the positive (+) and negative (-) terminals as shown inside the battery compartment. Replace the Battery Cover (16) and the Screw (15). See FIGURE 3 below.

FIGURE 3

Battery Cover (16)

9 Volt Battery

General Maintenance

1.Wipe the Level clean with a lint free cloth when needed.

2.Store the Level in a dry location where it will not freeze or overheat.

3.Before each use, inspect the Level to make sure nothing is cracked or broken. Do not use the Level if anything is cracked or broken. Have it repaired by an authorized service technician.

SKU 93884 For technical questions, please call 1-800-444-3353 Page 5