Assembly
The only assembly required is to install Side Handle (8), per the following instruc- tions. Using Cap Screws (7), and the supplied Allen Wrench, mount the Side Handle (8) to the Front Casing (5). Securely tighten all Cap Screws (7).
Note: Use pipe thread seal or Teflon tape on all threaded connections.
Oiler and Filter Connection
Dirt, water, and the lack of pneumatic tool oil are major causes for tool wear. It is recom- mended to install an optional
Connect the air tool, air hoses, filter, and oiler to the Compressor Air Outlet as illustrated below. The filter and oiler (not supplied) are recommended but not mandatory for opera- tion.
A few drops of pneumatic tool oil must be added through the air inlet before each use if an oiler is not used.
AIR SUPPLY CONNECTION
1.Install a standard 1/2” Air Connector (not included) to the Air Inlet (51). First wrap the threaded portion of the 1/2” air connector with pipe thread seal tape before threading it into the Air Inlet (51). Tighten securely.
2.Set the sir pressure regulator at no more than 100 PSI.
3.Check the air line and its connections for air leaks, make note of these, and repair them before using this tool.
WARNING: Do not exceed the recommended working pressure of 100 PSI. Damage to your tool, and possible personal injury may result.
SKU 94108 | For technical questions, please call | Page 5 |
