Unpacking
When unpacking, check to make sure the following parts are included.
Hand Held Metal Detector Wand
Carrying Case
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Operation
First install one 9 volt battery (not included).
1.Slide open the battery compartment cover, located at the base of the handle.
2.If there is an old battery in place, remove it. Insert one 9 volt battery (not included) into the battery compartment. Be sure that the polarity of the battery matches the correct poles marked “+” and
3.Slide the battery compartment cover back in place. Be sure it is closed tight.
The battery compartment
NOTE: This hand wand metal detector has a low battery warning system.
When the battery starts to get low, the detector will make a “chirping” sound instead of the normal steady tone when encountering metal. Also, the LED light will flash on and off rapidly when near metal. In this situation, replace the battery.
NOTE: You may use rechargeable batteries with this detector (not included).
If using rechargeable
WARNING: Do not attempt to recharge Alkaline or other
SKU 94138 | Page 4 |