8.CHECK FOR DAMAGED PARTS. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect its operation. Replace or repair damaged or worn parts immediately.
9.MAINTAIN PRODUCT WITH CARE. Keep this product clean and dry, and moving parts lightly lubricated for better performance. Keep the Handle dry, clean and free from oil, grease, and solvents.
10.USE THE RIGHT PRODUCT FOR THE RIGHT JOB. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There are certain applications for which this tool was designed. It will do the job better and more safely at the rate
for which it was intended. Do not modify this tool and do not use this tool for any purpose other than which it was intended.
UNPACKING
When unpacking, check to make sure all parts shown on the Parts List (page 5) are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
NOTE: Always mount the vise to a level workbench that is capable of supporting the weight of the vise and all
NOTE: All parts below refer to the parts listed on page 5 of this manual.
Setting Up The Vise:
1.Use the mounting holes on the Vise Plate (1) as a template. Lift the Vise against the workbench and, with a pencil, mark the points at which to fasten the Vise to the workbench. Set the Vise aside. See Figure 1 next page.
2.Drill the holes of the appropriate size (where previously marked with a pencil) into the workbench. Caution: Before drilling holes, always check to make sure that no hidden electrical wires or cords are in the drilling path.
3.Carefully set the Vise into place against the workbench with the mounting holes corresponding to the holes previously drilled through the top of the workbench.
4.Insert hardened steel bolts (not provided), of the appropriate diameter through the Vise Plate (1) and into the workbench. The length mounting bolts will vary, depending on the thickness of workbench the Vise it is to be attached to.
SKU 94386 | For technical questions please call | Page 3 |
