Operation
1.Connect the Floor Stapler to the air hose and turn on the air compressor.
Note: Before using on a floor, test the unit on a scrap piece of wood. Adjust the driving depth by providing more or less air pressure. Never exceed 125 PSI.
Warning! Keep your feet clear of the Stapler. Refer to Figure 2.
2.Hold the Handle (44) securely with one hand and grip the Hammer with the other hand.
| FIGURE 2 | |
| FIGURE 3 | |
| Hammer | |
Trigger (33) | Face (1) | |
(This helps prevent | (Striking this with the | |
Trigger (33) held causes | ||
unintentional firing.) | ||
the stapler to fire.) | ||
|
Fasteners exit the Stapler from the bottom in the
direction indicated above.
3.Make sure the Base Plate (52) is over the Fastener target position. Press down hard so that the Base Plate (52) is firmly contacting the floor. Then squeeze the Trigger (33) and strike the Hammer Face (1) with the Hammer to drive out a Fastener. Lift the tool off of the floor. See Figure 3.
4.Repeat the process until you are finished. Then, disconnect the Floor Stapler from the air source.
Warning! After disconnecting the Stapler from the air compressor, there could still be enough air pressure to fire the Stapler. After the air compressor hose is disconnected, always fire the Stapler into a piece of scrap to make sure all of the air is expended.
REV 11/06
SKU 94446 | For technical questions, please call | Page |
