TROUBLESHOOTING

Problem

 

Possible Solution

 

 

Jigsaw will not run, or runs with insufficient power.

1. Make sure to firmly squeeze the Power Switch. (See Figure E.)

 

2.

Make sure the Power Cord/Plug is plugged into a working 120 volt,

 

 

grounded, electrical outlet.

 

3.

Allow the tool to completely cool in the event of overheating. Then, resume

 

 

cutting.

 

4.

Have a qualified service technician check the Carbon Brushes for

 

 

excessive wear and/or debris build-up.

 

 

Quality of cut is poor.

1. Check to make sure the Saw Blade is sharp and undamaged.

 

2.

Make sure the Saw Blade is properly installed in the tool. (See Figure G.)

 

3.

Make sure to use the proper type of Saw blade for the material being cut.

 

 

(See Figure F.)

 

4.

Make sure to use the proper cutting speed for the material being cut. (See

 

 

Figure F.)

 

5.

Do not force the Saw Blade. Gradually feed the Saw Blade into the

 

 

workpiece.

 

 

Laser Guide will not illuminate.

1. Make sure the Laser Switch is in its “ON” position. (See Figure E.)

 

2.

Turn the Laser Switch to its “OFF” position. Then, check to make sure the

 

 

Laser Guide is free of excessive dirt and debris.

 

3.

Have a qualified service technician check the tool for internal damage.

 

 

The Power Switch does not turn off the tool.

Immediately unplug the tool from its electrical outlet, and have a qualified

 

service technician check the tool for damage and defects.

 

 

 

INSPECTION, MAINTENANCE, AND CLEANING

1.WARNING! Make sure the Power Switch (29) of the Jigsaw is in its “OFF” position and the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

2.Before each use, inspect the general condition of the Jigsaw. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, dam- aged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

3.Before each use, inspect the Saw Blade (68, 69). Using a dull Saw Blade will cause excessive wear on the Motor of the Jigsaw and will not produce a satisfac- tory cut. Replace with a new Saw Blade when needed. (See Figure G.)

4.To clean the exterior parts of the Jigsaw, use only a clean cloth and mild detergent to clean the body of the Saw. Do not immerse any electrical part of the tool in any liquids.

5.CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician.

SKU 94560

For technical questions, please call 1-800-444-3353

PAGE 14

Page 14
Image 14
Harbor Freight Tools 94560 operating instructions Troubleshooting, INSPECTION, MAINTENANCE, and Cleaning