Harbor Freight Tools 94582 operating instructions Assembly/Operation

10.Do not use or assemble the Tool Chest and Roller Cabinet if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not assemble or use the Chest and Cabinet.

11.Improper use can cause the Tool Chest and Roller Cabinet to tip over, causing personal injury or death. Load the chest evenly from the bottom up.

12.Do not exceed the Tool Chest and Roller Cabinet’s maximum weight capacity of 114 Lbs. The weight capacity for each Tray and Drawer is 11 Lbs.; Shelf capacity is 22 Lbs.

13.Always load the Tool Chest and Roller Cabinet evenly. If the Tool Chest is top-heavy, it may tip over when moved.

14.Use the Tool Chest and Roller Cabinet on a flat and level surface. This will lessen the chance of it rolling away and possibly causing injury.

WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Roller Cabinet

Screw

(2B)

Caster (1B)

Handle (9)

Figure 1 Figure 2

Assembly/Operation

Your Tool Chest and Roller Cabinet will require complete assembly. It is important that you read the entire manual to become familiar with the product BEFORE you assemble and use the Tool Chest and Roller Cabinet. Before assembling the Chest and Cabinet be sure that you have all parts described in the Parts List located on page 4 of this manual.

1.Insert each of the Caster (1B) shafts into the holes in the bottom of the Tool Chest and Roller Cabinet-see Figure 1.

2.Attach the Handle (9) to the side of the Roller Cabinet with two Screws (2B) and Nuts (3B)-see Figure 2.

3.Set each Shelf (8) down onto the lips built into the sides of the Roller Cabinet.

4.Set each of the Hooks (6B) in place on the Door.

5.Place the Tool Chest onto the top of the Roller Cabinet to have it stand as one unit.

6.If the Non-Slip Mats (4, 5) are not in place in the face drawers, place the Non-Slip Mats (4, 5) into each of the Drawers.

7.Make certain that the Tool Chest drawers lock when the top tray is closed.

SKU 94582 For technical questions please call 1-800-444-3353. Page 3