Harbor Freight Tools 94683 operating instructions INSPECTION, MAINTENANCE, and Cleaning

Models: 94683

1 12
Download 12 pages 44.78 Kb
Page 11
Image 11

INSPECTION, MAINTENANCE, AND CLEANING

1.CAUTION! Make sure the Power Switch is in its “OFF” position and unplugged from its Charger (6) before performing any inspection, maintenance, or cleaning of the Bug Vacuum.

2.Before each use, inspect the general condition of the Bug Vacuum. Check for misalignment or binding of moving parts, damaged or loose parts, dirt or debris in the Vacuum Filter and Mesh Screen, damaged electrical wiring, and any other condition that may affect the tool’s safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.

Do not use damaged equipment.

3.To clean: Flush the interior and clean the exterior of the Bug Vacuum accessories with a mild detergent. Then, allow to air-dry. Do not use solvents.

Do not immerse the Vacuum (1) in liquids.

4.When storing: Always completely empty the Bug Vacuum of dirt, debris, and insects. Make sure to store the Bug Vacuum and its accessories in a safe, dry, clean location out of reach of children and other unauthorized people.

5.To remove the internal NiCd battery: A technician should unthread the front portion of the Vacuum (1) and set it aside. Then, the four screws in the rear por- tion should be removed. The battery pack can then be removed and a replace- ment installed and sauter-connected to the wires. Always dispose of or recycle used NiCd batteries properly. For information on free battery recycling, please call 1-800-444-3353.

6.CAUTION! All maintenance, service, and repairs not discussed in this manual should only be performed by a qualified service technician.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

REV 08/06

SKU 94683

For technical questions, please call 1-800-444-3353

PAGE 11

Page 11
Image 11
Harbor Freight Tools 94683 INSPECTION, MAINTENANCE, and Cleaning, Please Read the Following Carefully