Harbor Freight Tools 95069 operating instructions Unpacking, Assembly, Operation, Using the Scale

Unpacking

When unpacking your 70 Lb. Digital Scale, check to make sure that all parts listed in the parts list on page 9 are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.It is important that you read the entire manual to become familiar with the product BEFORE you operate and use the Digital Scale.

Assembly

Your Digital Scale comes completely assembled. Only maintenance such as battery replacement may be required.

Operation

This product can be powered by an adapter or used with a 9V battery as the power source.

Using the Adapter

1.Plug the Charger Plug (30) into the Jack (24) located on the Scale. Plug the Charger Plug into a 120V electrical outlet.

2.When done using the Scale, unplug the Charger Plug (30) from the Digital Scale. Unplug the Charger Plug from the electrical outlet.

Changing the Battery

1. Batteries must be replaced if a picture of a battery is displayed in the LCD window. Gently push in on the tab on the Battery Cover (27) and pull the Battery Cover (27) up-see Figure 1.

2.Unplug the battery connecton from the Battery (26). Replace the dead Battery (26) with a new 9V Battery. Snap the battery connection back onto the top of the Battery.

		Figure 1
Battery		Battery (26)
	Cover (27)

battery compartment

Using the Scale

1.Press the Mode Key (see Figure 2) to set the Scale to the desired unit of weight, pounds or Kilograms.

2.The Scale has a Backstop (1) located on top of the Scale. Lift the Backstop (1). Set the item to be weighed against the Backstop (1). Failure to lift the Backstop (1) may

keep the Scale from operating properly.

3.Set the Scale on a level surface free from vibration and clear of electronic interference such as radios, phones and microwaves.

4.Press the On/Off Button to turn ON the Scale-see Figure 2.

SKU 95069 For technical questions please call 1-800-444-3353. Page 7