Page 4SKU 95154 For technical questions, please call 1-800-444-3353
1. Chose a wall or ceiling location that allows you to mount the unit onto a solid surface
capable of sustaining the weight of the unit. It is recommended that you choose a location
that is out of the reach of pedestrians. If you cannot mount the camera to a wall stud, you
will need to use the Dry Wall Mounting Anchors and Wood Screws (both not included).
2. It is essential to proper mounting that you use the correct size screws and that you also
space the two screw correctly. The exact distance between the two screws is 2.659”
(67.59 mm) center to center. You can make a pattern of the mounting holes by placing
a piece of tracing paper over the back of the Imitation Dome Camera and trace the
mounting holes location using a pen or pencil. Next tape the pattern over the area that
you want to install the camera. Mark the center of each mounting hole by hammering
a nail through the pattern into the mounting surface. Attach the screws to the mounting
surface leaving about a 1/4” of the screws’ shanks exposed.
Warning: When mounting, be sure to avoid hammering into any electrical wiring.
3. After the two mounting screw have been attached to the wall or ceiling, place the two
mounting holes on the camera over the screw heads. Press the Dome Camera over the
screw heads and twist the camera. This should secure it into place. Always be careful,
when drilling into a wall or ceiling, to avoid wires, pipe or cables that may be in the path
of the drill. Be aware that the Camera needs to be mounted securely so it will not fall off
the mounting and cause bodily injury.
note: The mounting holes on the Imitation Dome Camera are approximately 1/4” with 5/32”
slots. See Figure 4 below.
opeRation
Once the two AA batteries are installed in the Dome Camera, the LED light will
automatically blink in 5 second intervals until the batteries go dead. When the light stops
blinking, replace the batteries.
cameRa inStallation
FiguRe 1
Battery Housing
Mounting Holes
note: There are no replacement parts available for this product.