Loosening
1.Attach the correct size socket to the Anvil (8).
2.Set the compressor’s pressure regulator to 90 PSI. Do not set the compressor’s outlet regulator above 90 PSI.
3.Connect the Impact Wrench to the air compressor’s hose. If leaking is detected, disconnect the air hose and repair before use.
4.Place the socket over the nut to loosen.
5.Grip the Impact Wrench firmly. Press the Reverse Valve (44) in from the area above the Trigger (29) so that the Reverse Valve protrudes out the back of the Housing. Press the Trigger to start the Impact Wrench.
Caution: | Make sure the nut or bolt can withstand the Impact Wrench’s working |
| torque. |
6.If the Impact Wrench cannot loosen the nut, DO NOT raise the outlet pressure of the air compressor.
7.If the Impact Wrench’s Air Regulator is set on a low setting, you may raise the setting and try again. If the Impact Wrench’s Air Regulator is already set on the “4” setting, do not continue attempts to loosen the nut with the Impact Wrench. Use other appropriate tools and methods to loosen the nut.
8.When the nut is removed, stop the Impact Wrench by releasing the Trigger and remove the Impact Wrench from the nut. Remove the nut from the socket if needed.
Tightening
The working torque of the Impact Wrench is 250 foot/lbs. Make sure the nut or bolt you are using the Impact Wrench to tighten can withstand the rated torque.
1.Tighten the nut on as far as you can by hand.
2.Place the socket on the nut. Press the Reverse Valve forward so it protrudes out the front of the Housing. Press the Trigger to start the Impact Wrench.
3.If the Impact Wrench stalls while tightening, DO NOT raise the outlet pressure of the air compressor above 90 PSI.
4.If the Impact Wrench’s Air Regulator is set on a low setting, it may be raised before you try again. If the nut will not tighten at the maximum setting, do not continue attempts to tighten the nut. Use other appropriate tools and methods to tighten the nut.
SKU 95310 | For technical questions, please call | Page 5 |
