Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Attaching and Removing
the Bit
1.Insert the Shaft into a vise. Grasp the Bit with a wrench and unscrew the Bit.
2.Thread on the new Bit or flip to unused cutter side.
3.Remove Shaft and Bit from vise.
Operation Instructions
1.The Spot Weld Cutter is now ready to be mounted to the drill. Read the drill owner’s manual for instructions on properly mounting drill bits.
2.Before using the Spot Weld Cutter, make certain that the work piece is firmly clamped and secured in place. Place the Spot Weld Cutter Bit over the spot weld and slowly begin drilling into the work piece. Always hold the drill firmly with both hands to ensure safe operation of the Spot Weld Cutter. Note: If Bit does not stay in spot weld depression, dimple the center of the weld with a punch (not included).
3.Drill until the spot weld is removed. Do not over drill.
Note: When working on a vehicle, be certain to protect all electrical components from damage. Follow the vehicle owner’s manual for securing electrical systems. Make certain that the drilling path is clear of all cables, wires and electrical components.
a.Disconnect and isolate the negative battery cable and disarm the passive restraint system.
b.Protect computer modules, connectors, and wiring from dirt, heat, moisture and metal chips.
INSPECTION, MAINTENANCE,
AND CLEANING
1.WARNING! Make sure the Power Switch of the drill is in its “OFF” position and that the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
2.BEFORE EACH USE, inspect the general condition of the tool. Check for loose or broken parts and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
3.Clean the Spot Weld Cutter after each use. Remove any debris, grease, oil and dirt. Store in the Blow Mold Case in a secure place out of the reach of children.
SKU 95343 | For technical questions, please call | Page 3 |
