INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Make sure the Power Switch of the R/C Electric Racing Boat is in its “OFF” position and it is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
1.BEFORE EACH USE, inspect the general condition. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electri- cal wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
2.AFTER EACH USE, inspect the Racing Boat’s transmission shaft and bearing for water. Water may accumulate after each use, resulting in rust or blocked trans- mission shaft. Dry the transmission shaft by taking the propeller down, unscrew- ing and removing the shaft struts and drying the shaft and strut bearings. Adding lubricant to the shaft and bearings will also help prevent rust. Once done, reinstall all pieces.
Changing Boat Frequency
a. Turn off the boat and the remote control.
b. Open the tabs of the boat cover and unscrew the electric speed controller hous- ing.
c. Lightly hold down the circuit board and replace the crystal.
d. Screw down the electric speed controller housing and lock the top cover of the boat with the tabs.
e. Pull out and replace the crystal on the controller to match the crystal in the boat. The controller will only control the boat if it has the same frequency.
Troubleshooting
Problem | Possible Causes | Probable Solutions |
R/C Electric Racing | 1. Low Transmitter Batteries. | 1. Change the old |
Boat will not start |
| Transmitter (20) for new ones. |
| 2. Battery Pack (16) not connected to | 2. Remove the Deck Cabin (1) |
| the Electric Speed Controller (18). | and make sure the Battery Pack |
|
| (16) is properly connected to the |
|
| Electronic Speed Controller (18) |
|
| Refer to Figure 2. |
|
|
|
R/C Electric Racing | One, or possibly both of the Propellers | Turn off all power and check both |
Boat will not steer | (4A and 4B) are damaged or possibly | Propellers (4A and 4B) for damage or |
straight or follow | fouled with debris. | fouling and if necessary, replace one |
turning commands |
| or both. |
correctly |
|
|
|
| REV 07f |
SKU 95641 | For technical questions, please call | Page 13 |