Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Assembly Instructions
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.WARNING! Make sure the On/Off Button (2) is depressed and that the Vacuum is unplugged from an electrical outlet before assembling the Vacuum.
2.Install one Cap Nut (32) onto the Axle (30). Use a rubber mallet (not included) to
gently tap the Cap Nut until it |
| Vacuum shown assembled |
is firmly seated. Slide one |
| |
|
| |
Wheel (31) onto the Axle until |
| Metal |
it rests against the Cap Nut | ON/OFF | Handle (24) |
just attached. |
| |
Button |
|
3.Slide the Axle through the Large Wheel Base (29), and attach the other Wheel and Cap Nut onto the Axle as de- scribed above.
4.Press the Wheel Covers (33) onto the outside of each Wheel.
5.Align the Large Wheel Base with the bottom edge of the Canister on the opposite side from the Drain, and push down to lock the Large Wheel Base onto the Canister. Make sure both Wheels spin freely.
|
| Vacuum | |
|
| Assembly | |
Latch |
| Wet/Dry | |
|
| ||
|
| Vacuum | |
Storage |
| Connection | |
Container | Small Wheel | ||
Box (27) | |||
Base (22) | |||
| Handle (28) | ||
Wheel (31) |
| ||
| Drain | ||
|
| ||
|
| Casters (23) |
Vacuuming Tools
6.Align the Small Wheel Base (22) with the bottom edge of the Canister on the same side as the Drain and push down to lock the Small Wheel Base onto the Canister.
7.Insert Casters (23) into each side of the Small Wheel Base.
8.Push the Storage Box (27) firmly onto the top of the Large Wheel Base.
9.Slide the Metal Handle (24) into the Container Handle (28) on each side of the Canister and secure with Screws (20). Do not overtighten.
SKU 96325 | For technical questions, please call | Page |