Harbor Freight Tools 97055 Troubleshooting, Parts list, Problem Possible Solution

troubleshooting

Problem		Possible Solution
Sander does not start.	1.	Squeeze harder on Paddle Switch.
	2.	Make sure air compressor is set at 90 PSI.
	3.	Check for air leaks in air hose and all other compressed air
		connections.
	4.	Remove Quick Connector. Check Air Filter in Air Inlet for excessive
		debris build-up. If necessary, clean or replace Air Filter.
Sander will not remove material from	1.	Make sure Sanding Paper is not dull. If necessary, replace
workpiece, even after repeated attempts.		Sanding Paper.
	2.	Use a more course grit Sanding Paper.
	3.	Do not continue using Sander to avoid damaging workpiece. Use
		another method to remove material.
Sanding Belt slips off tool when in use.	1.	Loosen the Belt Adjusting Screw. Stretch the Sanding Paper tighter
		on the Adjusting Bar. Then retighten Adjusting Screw.

parts list

Part	Description	Qty.	Part	Description	Qty.
1	Body (with Bushing)	1	27	Nut	1
2	O-Ring	1	28	Angle Head	1
3	End Cap	1	29	Ball Bearing	1
4	C-Ring	1	30	Bevel Gear	1
5	Air Filter	1	31	Ball Bearing	1
6	Paddle Switch	1	32	Chuck Casing	1
7	Spring Pin	1	33	Key	1
8	Brush	1	34	Cap	1
9	Valve	1	35	Belt Track	1
10	O-Ring	1	36	Adjusting Bar	1
11	Spring	1	37	Spring	1
12	Speed Regulator	1	38	Nut	2
13	O-Ring	1	39	Spring	1
14	O-Ring	1	40	Cap	1
15	Valve Screw	1	41	Belt Tensioning Screw	1
16	Ball Bearing	1	42	Ball Bearing	2
17	Rear Plate	1	43	Spindle	1
18	Spring Pin	2	44	Belt Wheel	1
19	Cylinder	1	45	Spring Washer	1
20	Rotor	1	46	Nut	1
21	Vane	4	47	Belt Wheel	1
22	Steel Ball	1	48	Washer	2
23	Front Plate	1	49	Oil Hole	1
24	Ball Bearing	1	50	Air Inlet	1
25	Connector	1	51	Hex Wrench	1
26	Bevel Gear	1	52	Clamp Screw	1

REV 08k

SKU 97055 For technical questions, please call 1-800-444-3353. Page 10