one on each side, and six Nuts (5). Hand tighten the Nuts (5) initially (see Fig- ures 1 and 2).
Flat Washer | Nut |
|
Bolt 
Upright Post | Safety Pin |
|
Long Rod 
| Note: | Figure 2 |
| Foot Plate at | |
Short Rod | base of uprights |
|
| must rest on the |
|
| floor. |
|
3.Repeat step 1 to assemble the second Upright Post set.
4.Using two persons, stand up the two Upright Post assemblies in position and at- tach one Cross Beam (6) into the second Slot from the bottom of the two Upright Posts. These Cross Beams (6) have two metal Tabs on each end which slip into the Slots of the Upright Posts (2). Make sure the Flange on the Cross Beam (6) is facing up. This Flange will hold the Steel Shelves (7) in place (See Figure 1).
5.Repeat step 4 with a Cross Beam (6) on opposite side of Upright Post assembly.
6.Only one person is needed to finish the assembly. Continue to attach Cross
Beams (6) (Flanges pointing upward) at desired heights. The Cross Beams (6) on the top level must be positioned at the top Slot of the Upright Posts (2). Make sure each Cross Beam (6) is located in same Slots as the Cross Beam directly opposite its height on the Upright Post (2). This is to ensure that wneh the shelves are inserted, they will lay flat.
7.Use a rubber mallet (not supplied) to drive the Wedge at both edges of the Cross Beams (6) into the Slots on the Upright Posts (2) as deep as possible. Strike the Cross Beam (6) with the mallet as close to the Upright Post (2) as you can.
SKU 97563 | For technical questions, please call | Page |
