remove the Covers (3) to allow for insertion of the Screws.

8.Set the Lamp (1) to the angle height Drill holes for the enclosed screws. Make certain that the drilling path is clear of obstacles such as cables, gas and water pipes and electrical lines. Insert anchors into the holes. Thread in the enclosed Screws (5) to secure the Lamp (1) in position. NOTE: No anchors are needed if unit is mounted on wall studs.

9.Before mounting the Panel, make certain that the connecting wire will reach both the Lamp (1) and Panel

(2). Install the Solar Panel the same way that you installed the Lamp in step 8, using the mounting holes located on the base of the Panel. Insert Screws (4) through mounting holes in the base.

10.Adjust the Motion Detector Head be- low the light by moving it left or right so that it faces the area where move- ment will occur.

Operation

Read the entire Important Safeguards section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Figure 2

Connecting

 

 

 

On/Off Button

 

 

Wire (8)

 

 

1.Plug the Mounting Wire (8) into the Lamp as shown in Figure 2.

2.Before it can operate to its full capac- ity, the Security Light needs to be in sunlight for two to three days. Turn the On/Off Button (see Figure 2) to the “OFF” position and wait two to three days before use.

3.Turn the switch to the “ON” position and wait about a minute. The light will turn itself on and then shut off three times to calibrate itself.

4.Wait one minute after the self calibra- tion. The use the adjustment knob on the back of the motion sensor head to adjust the time that the light will stay on when the motion sensor detects movement.

5.The light will turn on automatically at night when motion is detected by the Motion Detector Head.

REV 08e

SKU 98085

For technical questions, please call 1-800-444-3353.

Page 5

Page 5
Image 5
Harbor Freight Tools 98085 manual Operation