Specifications
Motor | 120 V~ / 60 Hz / 15 A | |
n0 5300/min | ||
| ||
Arbor Diameter | 5/8” | |
Blade Type | General Purpose with | |
Carbide Tips | ||
| ||
Blade Diameter | 10” | |
| At 90°: | |
Cutting Capacity | Wide. At 45° | |
| x | |
Positive Table Stops | 0°, 15°, 22.5°, 30° and | |
45° Right and Left | ||
Positive Bevel Stops | 0° and 45° Left only | |
| 0° - 45° Right and Left | |
Blade Tilt Range | Miter | |
| 0° - 45° left | |
Scale | 1° per scale mark | |
| E105017 |
at the beginning of this manual including all text under subheadings therein before set up or use of this product.
WARNING To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
List of contents
Description | Qty |
Compound Sliding Miter Saw | 1 |
Carbide Tipped Blade | 1 |
Table Extensions | 2 |
Dust Collection Bag | 1 |
Wrench | 1 |
Initial Set Up
Instructions
Read the entire Important Safety Information section
Assembly
Attaching the Extension Supports and Miter Lock Handle
1.Insert the ends of the Extension Supports into the holes in the sides of the Base. Tighten the Wing Screws to hold the Extensions in place. The upper edge of the Extensions will be level with the surface of the saw. This provides a wider base for the work material to rest on.
2.Thread the Miter Lock Handle into the Plate until securely in place.
Attaching the Dust Collection Bag
3.The Dust Collection Bag slips over the Dust Outlet behind the Blade Housing Assembly. Sawdust created by cutting is captured in the bag.
SKU 98199 | For technical questions, please call | Page 9 |
