13.Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.
14.Check for damaged parts. Before using Filter/Regulator, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use any air tool if its switch does not turn On and Off properly.
15.Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other parts will void the warranty.
16.Do not operate air tools if under the influence of alcohol or drugs. Read warning labels if taking prescription medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the product.
17.Maintenance. For your safety, service and maintenance should be performed regularly by a qualified technician.
18.Before using any air tool, read and adhere to all instructions and safety warnings provided in the instruction manual of the air compressor being used. Be sure to use compressed air only.
Warning: The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety Code 25249.5 et seq.)
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that com- mon sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure all parts are included. Refer to the photo below, and the Parts List and Diagram located at the end of this manual. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Assembly
2A
1B
Figure 1
1.Remove the contents in the small plastic bag and locate Nipple (1B). Thread the Nipple (1B) into the side port of the Filter Cap (2A). You should use pipe thread seal tape or pipe dope (not included) on all threaded connections. See Figure 1.
SKU 98904 | For technical questions, please call | Page 3 |
